Hi there,

I recently updated to 1.5.0 and now I think we are experiencing a bug. We've never had this problem before 1.5.0.

We don't register our devices, we just do unregistered deployments/uploads.

After we network boot using ipxe bootloader, log in and select upload or deploy, we immediately get an error message:

** An Error Has Occurred **

...... Not Authorized

** Rebooting in One Minute **

This seems to happen sporadically.

Is there anything that I can do?

Here is a screenshot of the error:

Thanks!

@theopenem_admin I believe that fixed the issue. I stopped the proxy DHCP service, removed option 60 from the DHCP server, and switched off proxy DHCP in the settings page and set it to ipxe 64-bit. My old device is now loading! I would test the new HP 440 device, but we had to send it off. I'll have to test that device later, but I'm confident it will work now. Thanks for all the help!

@theopenem_admin Thanks! will try that tomorrow and see what happens.

@theopenem_admin Oh, I didn't realize that. I do have Toem's DHCP proxy installed and running. I'll need to take a look at the instructions again. I set it all up years ago. It sounds like I may not even need the DHCP proxy, we only have 64-bit EFI devices now.

@theopenem_admin Also, we have two other DHCP policies set up for 32-bit and BIOS respectively in the DHCP server. But, we really don't use them these days.

ipxe.zip @theopenem_admin We are using the DHCP proxy. Here is a screenshot of the options in the server.

Also, I attached my original ipxe file that works.

ipxe.zip

Thanks for the help!

@theopenem_admin I copied the old ipxe file back and updated the pxe settings. I get this error when I do that, I don't know if it would be relevant.

"Updated Settings Successfully, But Could Not Copy PXE Binaries On One Or More Com Servers. Check The Logs For More Info"

The old file works on my old device again.

@theopenem_admin Yea, unfortunately. I just tried an older device that worked before again and it times out trying to download the default.ipxe file.

@theopenem_admin Good morning! Any luck adding that TFTP path to the ipxe image? Thanks!

@theopenem_admin
Thanks! I poked around on this end and wasn't able to get anywhere.

@theopenem_admin
Thanks! I just tried it out. Looks like we're making some progress. Unfortunately, now I'm getting this timeout error after pulling down the default.ipxe file. I'll keep poking around.