Lost 300 endpoints. Restoration possible?
-
I actually have access to run a script to those machines from another endpoint management program.. where would I find all these values and to add to the script like the provision key and ca and for com server just put the com server url? Thanks so much I will prepare a script when I hear back from you then give this a try.
-
Admin Settings->Toec->Client MSI Arguments
-
@theopenem_admin and last question… these would have to be three separate scripts one at a time or just one script? Thanks again!
-
One is fine. I would probably stop the toec service before and start it at the end.
-
I’ll be deploying the script through fog. I wonder if it might just be easier to run a command to uninstall toec would that be toec.exe - - uninstall and then run redeploy the new toec client?
-
@theopenem_admin I ran these commands and the resets seem to go through however after rebooting I get an error in the log that states it cannot find certificate authority with thumbprint ….. and then the thumbprint I entered. I omit the posts in your command correct and just use the actual thumbprint? Thanks again for all your help.
-
Did you run this on all of them or just a test? It seems those commands cleared out the needed cert. You would need manually push out the Toems CA to these computers. It's probably easier just to reinstall Toec.
-
@theopenem_admin thank you for your response. Just one of them. Would you happen to have a command to uninstall toec or would I have to grab software identifier from the registry?
-
You would need to grab it from the registry. You should just be able to install over top of it though. Can't remember if the same version will reinstall on itself, but if you upgrade to the latest version it should allow you to just install it again.
-
@theopenem_admin oh excellent I’ll try to install it right over top of the existing toec client. Fingers crossed it will refresh the connection to the new server. Thanks again.